Oxidation and carburization behaviour of two type 316H stainless steel casts in simulated AGR gas environment at 550 and 600 °C

The time-dependent oxidation and carburization behaviour of two type 316H austenitic stainless steels with varying Mn content and differing average austenite grain size of 142 µm in ‘Low Mn’ (0.98 wt.% Mn) and 81 µm in ‘High Mn’ (1.52 wt.% Mn), were assessed at 550 °C and 600 °C in the presence of simulated reactor primary gas coolant containing 500 vppm H₂O, 100 vppm H₂, 300 vppm CH₄ and 1 vol.% CO, balanced with CO₂. Rupture and spallation of the initial protective chromia layer occurs in the ‘High Mn’ steel after 2000 h at 550 °C, and leads to the formation of a magnetite/spinel oxide layer that reaches 75% surface coverage only after 8000 h. In contrast, ‘Low Mn’ steel reaches ~ 85% coverage after only 1000 h at the same temperature. The development of an inner carburized layer occurs gradually in both steels once the duplex oxide layer is forming. The differences in steel behaviour are reduced at 600 °C, where both oxidation and carburization are significantly accelerated. Only 0.02 wt.% carbon remains in solid solution in the austenite lattice in the carburized layer, the excess carbon atoms precipitating out in the form of Cr-rich M₂₃C₆ particles, present both inter- and intragranularly. The experimental values of the activation energy for carburization suggest that diffusion of substitutional solutes as the rate-limiting mechanism of the process. Previously observed carburization depths of ≥ 200 µm in ex-service austenitic stainless steels, may be achieved by pre-conditioning 316H steel in simulated reactor gas coolant for ≥ 6000 h at 600 °C.